4 Axis and Spindle Parallel Interface 1.0
4axis-front.jpg4axis-back.jpg

Schematic: PDF
PCB solder side: PNG
PCB holes: PNG
Assembly diagram: PDF

Assembly notes:
Since this board is a through hole board, you'll need to mill it in two steps. The first step is to mill the traces using a 1/64" end mill as usual. Then change to a 1/32" end mill and mill the holes. Use a Z depth of -.065" for the holes and XY speed 0.5, Z speed 0.5.

Unless otherwise stated, the content of this page is licensed under Creative Commons Attribution-ShareAlike 3.0 License