Brute Force Stepper Driver 1.3
bf-top.jpgbf-bottom.jpg

Schematic: PDF
Bill of materials: (email for file)
Layout solder side: PNG
Layout holes: PNG

Example EMC config for use with the brute force driver: ZIP
Note that the above config is for a parallel port with address 0x1410, you might need to change that to something like 0x378.

This version of the brute force driver requires that your supply voltage and motor voltages be a close match. For example if you're using a 12V supply, use a 12V unipolar motor.

Unless otherwise stated, the content of this page is licensed under Creative Commons Attribution-ShareAlike 3.0 License